5.2 Common Menus Setting 207
[Adjust Finisher]
Adjust the punch hole position and fold position when the C3 Finisher (optional) or the C3
Finisher with Booklet Maker (optional) is installed.
Admin Menu
Adjust Finisher
Adjust Finisher
Hole Punch Tool
Adjust Finisher
Fold Assist Crease
Setting Description
Hole Punch Tool Selects the type of installed hold punches (optional).
• 2/4 Hole Punch
•2/3 Hole Punch (US)
Note
• This option can be set when 2/4 Hole Punch or 2/3 Hole Punch (US) is installed.
Fold Assist Crease Sets whether or not to make crease(s) to assist folding.
• [No Crease]
• [1 Crease per Side]
• [2 Creases per Side]
• [3 Creases per Side]
To Next Page
Loading...
