1.2 Connecting a cable 31
1.2 Connecting a cable
Connect the printer to your computer using an interface cable appropriate for your connection
method.
An interface cable is not included with the printer. You must purchase it separately.
The installation procedure varies depending on how your computer is connected to the printer.
For more information, refer to "1.7 Installing a Print Driver" (P. 46) and the 'Manual (HTML)' on
the Media (Software/Product Manual).
USB Connection
The following explains how to connect the printer to your computer using the USB cable.
1. Plug the USB cable into the USB interface
connector on the printer.
2. Plug the other end of the USB cable into your
computer.
Note
• Message [Ready to print IP Address failed] may be displayed on the control panel. To erase this message, set to
[STATIC] in [Network/Port] > [TCP/IP Settings] > [IPv4 Settings] > [Get IP Address] to specify IP address (Example:
192.0.2.1) or [Disabled] for each port other than the USB port in [Network/Port].
Refer to
• For setting method of IP address, refer to "Setting the Network Environment" (P. 37).
• For setting each port, refer to "Enabling Ports" (P. 41).
To Next Page
Loading...
Need help?
General
