1.6 Configuring the Printer Using CentreWare Internet Services 45
Note
• When specifying a port number, enter a
“
:
”
(colon) and then
“
80
”
(the factory default port number) after the
address. Verify the printer's port number by printing [Configuration Report].
• The port number can be changed under the [Properties] tab > [Connectivity] > [Protocols] > [HTTP]. If you change
the port number, you must enter a
“
:
”
(colon) and then the port number after the address.
• Displays a screen for entering the user name and password when the Authentication function is set. Enter the ID
and password of the administrator or user registered on the printer. Contact your administrator for information
on your ID and password. User information is displayed on the upper right when CentreWare Internet Services is
started up.
• After you logged in with the ID and password for administrator or the user registered in the printer to configure
and confirm settings, make sure to click [Logout] to log out the system in order to prevent the leakage of
information.
• When data encryption is enabled, enter
“
https
”
instead of
“
http
”
before the address when accessing CentreWare
Internet Services.
• For information about data encryption features, refer to "7.9 Security Features" (P. 327) and "7.11 Control Access to
Printer Features by Pre-registering Users" (P. 349).
Using the Online Help
For information about the settings on each screen, refer to the online help for CentreWare
Internet Services. Click [Help] to display the [Help] window.
Important
• To display the online help for CentreWare Internet Services, users need to have the environment to connect to the
internet. The communication fee shall be borne by you.
To Next Page
Loading...
Need help?
General
