306 7 Maintenance
Disposal procedure
1. Make sure that the machine is not operating,
and open the finisher front door.
2. Pull out the hole punch waste container [R4].
3. Empty the container.
4. Insert the emptied hole punch waste
container into its original position until it
stops.
5. Close the finisher front door.
Note
• If the front door is not closed completely, a message
appears and the machine will remain paused.
Replacing the Fusing Unit
The following messages appear on the printer’s control panel when the fusing unit is near or
reaches the end of its service life.
To Next Page
Loading...
