5.2 Common Menus Setting 155
[Port 9100]
Adobe Protocol Sets the PostScript communication protocol.
• [Normal] (default)
Select this when the communication protocol is in ASCII format.
• [Binary]
Select this when no special processing is required for data. Some data is printed
slower than with the [Normal] protocol.
•[TBCP]
Select this when the communication protocol is both in the ASCII and binary
formats, and switches between the two using control codes.
•[RAW]
Select this when the communication protocol is in Raw format. Select this item
when EPS files cannot be printed properly from Macintosh computers using a
USB interface.
Note
• Select an appropriate option according to the data format specified on your print
driver.
• [Adobe Protocol] is enabled only when printing in PostScript.
• Normally, use this setting at its default [Normal].
PS Wait Timeout Sets the print waiting time for PostScript.
• [Disabled] (default)
[Auto Eject Time] of [USB] is used.
•[Enabled]
[PS Wait Timeout] for PostScript print driver is used.
Network/Port
Port 9100
Port 9100
Port Status
Port 9100
Print Mode
Port 9100
PJL
Port 9100
Connect Time-Out
Port 9100
Port Number
Port 9100
TBCP Filter
Setting Description
Port Status Sets whether to enable or disable the Port9100 port at printer start-up.
•[Enabled] (default)
•[Disabled]
Important
• If the printer runs out of memory when the port is enabled, the port is sometimes
automatically disabled. If this happens, either disable unused ports, or change
the memory allocation under [Allocate Memory].
Setting Description
To Next Page
Loading...
