116 U41117-J-Z125-7-76
Starting GXCC Operating and monitoring CentricStor
5.3.8 Selecting the CentricStor system
If the local system is not part of CentricStor, the Unit Select menu is displayed when GXCC
is started.
Example
The operation and functions of Unit Select are described in the section “Select” on
page 147. Errors that occur when a connection is established after clicking on “OK” are
handled differently because no connection yet exists to CentricStor.
5.3.9 Establishing a connection after clicking on OK
An attempt is made to address the host selected in the list. If this is not possible, an error
message will be displayed. As soon as you acknowledge this message, the “Unit Select”
menu will reappear.
Once the connection has been established, GXCC checks whether or not an InfoBroker is
running on the processor.
– If none is running, the connection will be shut down. Once the error message has been
acknowledged, the “Unit Select” menu will be displayed again.
– If the computer contains an InfoBroker, a connection is set up between GXCC and the
InfoBroker. After a brief interval and successful authentication (see the next section),
the main window will appear on the screen.
Clicking the “Cancel” button allows you to exit GXCC. Any changes to the unit list made
using “Add”, “Remove” or “Replace” will remain effective.
To Next Page
Loading...
Need help?
General