494 U41117-J-Z125-7-76
Message lines Explanation of console messages
SXRP
051
RPLM(
#51)
: ERROR
: <p
ds>
repo
rts err
no =
<nu
m> (
<strin
g> )
on P
V <n
ame>
Meaning
The PDS has detected an error.
Response
Notify maintenance staff if necessary.
SXRP052 RPLM(#52): NOTICE: PLS reports VOLUME ERROR for PV <pv>, PV-file will be removed
Meaning
The physical library does not know this PV.
Response
Check the VSN of the PV, correct it, and notify the robot of the new VSN.
9.2.17 SXSB... (Sadm Driver: SCSI bus error)
SXSB001 chim1 (sadm9): SCSI-Bus reset
None
Meaning
This message is part of a message complex (see the section “Bus Reset for SCSI
Controller” on page 542).
SXSB003 chim1 (sadm9): reinit of target <t> lun <l> failed
None
Meaning
One of the targets could not be initialized again after a bus reset. As this initialization is
repeated automatically, this message can be ignored.
SXSB005 chim1 (sadm9): RESETTING CONTROLLER
None
Meaning
This message is part of a message complex (see the section “Bus Reset for SCSI
Controller” on page 542).
To Next Page
Loading...
Need help?
General