188 U41117-J-Z125-7-76
Function bar GXCC
6.2.7.4 Distribute and Activate
Then Distribute and Activate function is normally called after a change has been made to
the configuration.
The changed configuration files are distributed to all the CentricStor processors. The
software licenses in the VLP are distributed as required.
Options for “Mode”
Activate_pending_config
This setting is always selected by default. It causes the current configuration changes
to be distributed and activated. After this function has been executed, the identifier for
configuration changes (diskette icon) is deleted.
Activate_last_config
When this option is selected, the current configuration is stored, and then the last con-
figuration is distributed and activated. If this function is then selected once more, you
return to the starting point which existed before the first time Activate_last_config was se-
lected.
Reset_pending_config
This selection causes the configuration data which has not yet been activated to be dis-
carded. After this function has been executed, the identifier for configuration changes
(diskette icon) is deleted.
Reactivate_failed_config
This option causes the configuration to be activated without it being distributed. Activa-
tion without distribution is permitted only for ISPs which are marked by an error flag. In
the case of ISPs without an error flag, this action is an empty command. The purpose
of reactivation is to provide the option of rebooting after the original error situation on
the ISP concerned has been cleared.
To Next Page
Loading...
Need help?
General