560 U41117-J-Z125-7-76
E-mail support in CentricStor Appendix
12.2.3 Configuring the e-mail template
The configurable data of the e-mail can be set in e-mail-format-specific configuration files.
The configuration file must be created by copying a sample file and then be adapted to the
conditions.
If a customer-specific configuration file exists for an e-mail format, an e-mail is created and
sent in accordance with the configuration file.
The following entries can be configured in each e-mail-format-specific configuration file:
– Recipient
– Selection criterion
Recipients
Up to 8 recipients can be entered.
Example
# list with the recipients of the error information mail
#
RECEIVER1=""
RECEIVER2=""
RECEIVER3=""
RECEIVER4=""
RECEIVER5=""
RECEIVER6=""
RECEIVER7=""
RECEIVER8=""
Selection criterion
The Message Management defines which error messages can be sent by e-mail. In the
configuration file it is only possible to reduce this set. The criterion used for this purporse is
the error weight of a message (see section “General” on page 441).
Example
# define error levels to be reported by email
# values: yes/no
#
MAIL_NOTICE="no"
MAIL_WARNING="no"
MAIL_ERROR="no"
MAIL_CRITICAL="yes"
MAIL_ALERT="yes"
MAIL_EMERGENCY="yes"
To Next Page
Loading...
Need help?
General