344 U41117-J-Z125-7-76
Function bar XTCC
8.3.6 Profile
The term “profile” encompasses all user-specific settings chosen under “Options” and
“Autoscan”. These settings are stored in a user-specific subdirectory.
When the main menu functions
–Unit ➟ Select
–File ➟ Select
–File ➟ Exit
– Options ➟ Settings ➟ OK
– Options ➟ Apply Current Aspect
– Autoscan ➟ Settings ➟ OK
– Profile ➟ Select ➟ OK
are called, the following settings which are used are backed up implicitly on a unit-specific
basis:
– Options Settings Size, For Infobox: Move Pointer for Info / Click Button for Info,
Help in: English/German
– Autoscan Settings Autoscan Delay, Mode: Manual/Self Adjusting, Scan on function
completion: Enable/Disable
– and the current size and position of the window on-screen (aspect)
A backup operation does not take place if XTCC is terminated by some means other than
selecting File ➟ Exit.
Note that if you change the position or size of the window on the screen using the
Options ➟ Apply Current Aspect function you must confirm this.
The next time a unit is selected, the values that have already been stored are used
again. If the command line arguments -aspect, -autoscan, -lang, -size were
specified at the start, these will have priority over values which have already been
saved and, as described above, will also be saved implicitly.
i
i
To Next Page
Loading...
Need help?
General