570 U41117-J-Z125-7-76
Transferring volumes Appendix
12.3.5.4 Removing an LV from a transfer list
This command enables an LV to be removed from the list of LVs to be transferred. If it has
already been transferred, the command is rejected.
If no LV is specified, the entire transfer-out is aborted. Existing save requests are still
processed.
Example
AZUR-VLP0# plmif trans -o -c
transfer-out cancelled.
12.3.5.5 Skipping an LV / removing a PV
The -v option is used to skip an LV. This is only possible if the PLM is waiting for a VLM
restore request, otherwise the command is rejected. This is useful if the VLM does not know
the LV concerned and the LV is not to be created.
The -V option enables you to remove a complete physical volume which was added
inadvertently. This can only be done if the PV is not mounted in a PDS.
12.3.6 Special situations
If you do not wish PVs with the 'read' status to really be deleted but to be reused, you must
remove them using plmif trans -o -G and then add them again using the command
plmif conf -a -f (-f=force: omit header check).
plmif trans -o -c [ -v <LV> ]
plmif
trans -i -c (
-v <LV>
| -V <PV
> )
To Next Page
Loading...
Need help?
General