448 U41117-J-Z125-7-76
Message lines Explanation of console messages
SXCH
004
E
SCON
-ad pcea
<port
> (bus
<pci-b
us> dev <p
ci-de
vice
>) sta
rted
NOTICE
Meaning
The ESCON port <port> has been activated. This happens regularly at system startup. A
port can also be reactivated after being reset or deactivated.
SXCH
005
E
SCON
-ad pcea
<port
> (bus
<pci-b
us> dev <p
ci-de
vice
>) Mem
ory error
ALERT
Meaning
A memory error has occurred on the ESCON board. The driver was requested to perform
a board reset and to recalibrate the memory.
Response
The board is operational again following a successful reset. However, if this error occurs
again, you are recommended to replace the board.
SXCH
006
E
SCON
-ad<bo
ard> (b
us <pc
i-bu
s> dev <pci
-dev
ice> se
r_nr
<serial-
nr>)
defec
tive
ALERT
Meaning
Error when starting the ESCON board (PCEAS/PCEAT). This error is reported when a me-
mory BIST (Built-in Self Test) has not been executed correctly and in the event of the board
firmware not being loaded completely.
Response
Replace the ESCON board.
SXCH
007
E
SCON
-ad<bo
ard> (b
us <pc
i-bu
s> dev <pci
-dev
ice>)
defec
tive
ALERT
Meaning
Error when starting the ESCON board (PCEAF). This error is reported when a memory
BIST (Built-in Self Test) has not been executed correctly.
Response
Replace the ESCON board.
SXCH008 ESCON-adaptor <board> (ser_no <serial-nr>) Board Reset Failed
ALERT
Meaning
A board reset triggered by a memory error (SXCH005) could not be performed successfully.
Response
Replace the ESCON board.
To Next Page
Loading...
Need help?
General