Fujitsu Siemens Computers pmn - Page 468

468 U41117-J-Z125-7-76
Message lines Explanation of console messages
SXPL011 PLM(#11):NOTICE: number of free PVs of PV-group <PVG> over absolute minimum
(<
num>) again
Meaning
The number of free tapes is again greater than the absolute minimum.
SXPL012 PLM(#12): ERROR: <PDS-name> doesn't eject a volume, probably hardware error
Meaning
The PDS <PDS-name> has not ejected a physical volume in such a way that the robot can
grab it.
Response
Check whether the physical volume involved is jammed in the device identified by the PDS
number.
SXPL013 PLM(#13): ERROR: <PDS-name> reports media error on PV <PV-name>
Meaning
A media error has been reported on the physical volume <PV-name>.
Response
The physical volume has been marked by the PLM as read-only. Any logical volumes still
located on this physical volume should be moved by means of a reorganization. Once this
has been done, replace the physical volume. If a read error occurs during reorganization,
this fact will be reported by the PLM error message SXPL020 (see page 474).
SXPL014 PLM(#14): ERROR: <PDS-name> reports hardware error
Meaning
The PDS <PDS-name> has reported a hardware error.
Response
Notify maintenance staff.
SXPL015 PLM(#15): ERROR: <PDS-name> reports sense = <Sense-Byte-Value> on PV <PV-name>
Meaning
The PDS <PDS-name> has reported an error code for the physical volume <PV-name>.
Response
Notify maintenance staff.
SXPL016 PLM(#16): ERROR: <PDS-name> reports error = <PDS-error-string> on PV <PV-name>
Meaning
The PDS <PDS-name> has reported a class-3 error (ERR_PDS_03...).
Response
The meaning of the error texts transferred in <PDS-error-string> and any actions to be
taken are listed below.