526 U41117-J-Z125-7-76
Message lines Explanation of console messages
Response
The function should already have been stopped on the VLP; if it has not been, it must be
stopped on the VLP. The additional messages must be taken into account; detailed infor-
mation is stored in the log_VLPwatch and log_vlpwatch files in the logging directory
/etc/vtls/log. The function can then be restarted via the interface.
SXVW016 VLPWATCH: ALERT: VW(#016) AutoVLP-Failover: switch VVLP to SVLP failed!
Meaning
The switchover of the VLP to a SVLP was aborted. The requirements were not met!
Response
The function should already have been stopped on the SVLP; if it has not been, it must be
stopped on the SVLP. The additional messages must be taken into account; detailed infor-
mation is stored in the log_VLPwatch and log_vlpwatch files in the logging directory
/etc/vtls/log. The function can then be restarted via the interface.
SXVW017 VLPWATCH: ALERT: VW(#017) AutoVLP-Failover: Failover defect: configurate new -
terminated!
Meaning
The AutoVLP failover function is in an undefined status.
Response
Deconfigure the function, distribute it and then reconfigure it.
SXVW018 VLPWATCH: ALERT: VW(#018) AutoVLP-Failover: communication sector could not be
determined! (fc-card may have changed)!
SXVW018 VLPWATCH: ALERT: VW(#018) AutoVLP-Failover: connection to LAN and start of vtls
prevented!
SXVW018 VLPWATCH: ALERT: VW(#018) AutoVLP-Failover: please reconfigure this function!
Meaning
The hardware has changed; the assignment of VLP/SVLP is no longer definitely possible.
Response
The function must be deconfigured. This can only take place by performing several manual
activities.
SXVW019 VLPWATCH: ALERT: VW(#019) AutoVLP-Failover: communication sector corrupted!
Meaning
The communication sector on RAID1 is unusable or has been destroyed. The function can
no longer be guaranteed and has been terminated.
Response
The function must be deconfigured. The preceding messages must be taken into account;
detailed information is stored in the function log. The communication sector is created again
by subsequently reconfiguring the SVLP.
To Next Page
Loading...
Need help?
General