4.6 Using the System Settings Menus
fi-6010N Network Scanner Operator's Guide 61
4
6. Press the [Now] button.
The system is restarted.
z If the new scanner name is the same as another device name already in
use on the network, communication problems will occur. In this case, try
the following steps:
1. Disconnect the LAN cable, and press the [Shutdown] button on the
touch panel to turn the scanner off.
2. Reboot the scanner with the LAN cable disconnected, and enter a
non-duplicate scanner name.
3. Reboot the scanner again.
4. Re-connect the LAN cable to the scanner.
z The connection will be lost if the scanner name is changed via the network
interface. To continue with other settings, wait a short time for the device to
restart, then login to the network interface again.
To Next Page
Loading...
