Fujitsu PRIMERGY RX2530 M6

Using Infrastructure Manager
When using Infrastructure Manager and replacing LAN controller or system
board, you have to deapply the profile before replacing and apply the profile
again after replacing.
Please refer to the following manuals of the Infrastructure Manager.
See manual "FUJITSU Software Infrastructure Manager Vx.x.x User's
Guide", section "2.4.2 Profiles and Policies", available at:
https://ts.fujitsu.com/support/
For Japan:
See manual "FUJITSU Software Infrastructure Manager Vx.x.x 解説書",
section "2.4.2 プロファイルとポリシー", available at:
https://www.fujitsu.com/jp/products/software/infrastructure-software/
infrastructure-software/serverviewism/technical/
After replacing or upgrading LAN controllers
▶
You need to restore the configuration for the LAN Teaming, using the LAN
driver utility or OS teaming software.
Ensure that the controllers have been assigned as primary or secondary
according to your requirements.
For more information, see the relevant LAN driver manual.
After replacing a system board
The following procedure must be done for each system board that is
replaced.
▶
Confirm with the customer whether the onboard LAN controller you have
replaced has been used as part of a LAN teaming configuration.
▶
If LAN teaming has been active, you will need to restore the configuration
using the LAN driver utility or OS teaming software.
For more information, see the relevant LAN driver manual.
Basic software procedures
RX2530 M6 Upgrade and Maintenance Manual 101