1 Power cable to HDD backplane and connector "PWR5" on system
board
2 OOB cable to HDD backplane and connector "SMB3" on system
board
3 SATA cable depending on configuration
Concluding steps
▶
Install the HDD/SSD modules in the rear HDD/SSD cage, see "Installing a
2.5-inch HDD/SSD module" on page
141.
▶
"Reassembling" on page 57
.
▶
"Connecting the power cord" on page 62.
▶
"Switching on the server" on page 66.
▶
If applicable, "Installing the front cover with lock" on page 66.
7.6 EDSFF SSD configurations
7.6.1 Overview of configurations
7.6.1.1 Configuration with up to 32 EDSFF SSD modules
Figure 97: Numbering of the EDSFF SSD modules
Position Logical drive
number
ServerView RAID Manager display
name
[0] 0 Vendor Product (0)
[1] 1 Vendor Product (1)
Hard disk drive (HDD) / solid state disk (SSD)
174 Upgrade and Maintenance Manual RX2530 M6
To Next Page
Loading...
