Concluding steps
▶
Install the corresponding riser module, see "Installing a riser module" on
page 69.
▶
"Reassembling" on page
57.
▶
"Connecting the power cord" on page 62.
▶
"Switching on the server" on page 66.
▶
If applicable, "Installing the front cover with lock" on page 66.
▶
If applicable, update the system information of your server using the Chassis
ID Prom Tool, see "Using the Chassis ID Prom Tool" on page 98.
▶
"Updating expansion card firmware" on page 83.
▶
"Resuming BitLocker functionality" on page 93.
9.6.3 Removing an expansion card
Upgrade and Repair Unit
(URU)
Hardware: 5 minutes
Tools: Phillips PH2 / (+) No. 2 screw driver
Preliminary steps
▶
"Suspending BitLocker functionality" on page 75.
▶
If applicable, "Removing the front cover with lock" on page
48.
▶
"Shutting down the server" on page 48.
▶
"Disconnecting the power cord" on page 49.
▶
"Getting access to the component" on page 52.
▶
Remove the corresponding riser module, see "Removing a riser module" on
page 69.
Expansion cards and backup units
228 Upgrade and Maintenance Manual RX2530 M6
To Next Page
Loading...
