Fujitsu PRIMERGY RX2530 M6 User Manual

Concluding steps
▶
Install the corresponding riser module, see "Installing a riser module" on
page 69.
▶
"Reassembling" on page
57.
▶
"Connecting the power cord" on page 62.
▶
"Switching on the server" on page 66.
▶
If applicable, "Installing the front cover with lock" on page 66.
▶
If applicable, update the system information of your server using the Chassis
ID Prom Tool, see "Using the Chassis ID Prom Tool" on page 98.
▶
"Resuming BitLocker functionality" on page 93.
9.6.4 Replacing an expansion card
Upgrade and Repair Unit
(URU)
Hardware: 10 minutes
Software: 5 minutes
Tools: Phillips PH2 / (+) No. 2 screw driver
Note on network settings recovery
When replacing network controllers, network configuration settings in
the OS will be lost and replaced by default values. This applies to all
static IP address and LAN teaming configurations.
Ensure to note down your current network settings before replacing a
network controller.
Preliminary steps
▶
"Locating the defective server" on page 45.
▶
If applicable, "Removing the front cover with lock" on page
48.
▶
If applicable, "Configuring LAN teaming" on page 100.
▶
"Suspending BitLocker functionality" on page 75.
Expansion cards and backup units
230 Upgrade and Maintenance Manual RX2530 M6

Fujitsu PRIMERGY RX2530 M6 Specifications

General

Brand	Fujitsu
Model	PRIMERGY RX2530 M6
Category	Server
Language	English