Concluding steps
▶
Install the riser module 2 and riser module 3, see "Installing a riser module"
on page 69.
▶
"Reassembling" on page
57.
▶
"Connecting the power cord" on page 62.
▶
"Switching on the server" on page 66.
▶
If applicable, "Installing the front cover with lock" on page 66.
16.6.4 Replacing an M.2 SSD
Upgrade and Repair Unit
(URU)
Hardware: 5 minutes
Software: 15 minutes
Tools: Phillips PH2 / (+) No. 2 screw driver (for cover 2)
Preliminary steps
▶
"Locating the defective server" on page 45.
▶
If applicable, "Removing the front cover with lock" on page
48.
▶
"Shutting down the server" on page 48.
▶
"Disconnecting the power cord" on page 49.
▶
"Getting access to the component" on page 52.
▶
Remove the riser module 2 and riser module 3, see "Removing a riser
module" on page 69.
Replacing the M.2 SSD
▶
Remove the defective M.2 SSD, see "Removing the M.2 SSD" on page 370.
▶
Install the new M.2 SSD, see "Installing the M.2 SSD" on page 365.
System board and components
RX2530 M6 Upgrade and Maintenance Manual 371
To Next Page
Loading...
