Preliminary steps
▶
If applicable, "Removing the front cover with lock" on page 48.
▶
"Shutting down the server" on page
48.
▶
"Disconnecting the power cord" on page 49.
▶
"Getting access to the component" on page 52.
▶
Remove the riser module 1, see "Removing a riser module" on page 69.
Replacing the VROC module
▶
Disconnect the VROC module from the VROC connector on the system
board, see "Removing the VROC module" on page 384.
▶
Connect the VROC module to the VROC connector on the system board,
see "Installing the VROC module" on page 382.
Concluding steps
▶
Install the riser module 1, see "Installing a riser module" on page 69.
▶
"Reassembling" on page 57.
▶
"Connecting the power cord" on page 62.
▶
"Switching on the server" on page 66.
▶
If applicable, "Installing the front cover with lock" on page 66.
16.9 System board
16.9.1 Replacing the system board
Field Replaceable Unit
(FRU)
Hardware: 40 minutes
Software: 20 minutes
System board and components
RX2530 M6 Upgrade and Maintenance Manual 385
To Next Page
Loading...
