▶
"Shutting down the server" on page 48.
▶
"Disconnecting the power cord" on page
49.
▶
"Getting access to the component" on page 52.
▶
"Locating the defective component" on page 46.
▶
Remove the corresponding riser module, see "Removing a riser module" on
page 69.
Removing the defective expansion card
▶
Remove the expansion card, see "Removing the expansion card" on
page 229.
▶
If the slot bracket on the defective expansion card is to be reused, remove it
from the expansion card, see "Removing a slot bracket" on page 201.
Installing the new expansion card
▶
If applicable, install the slot bracket, see "Installing a slot bracket" on
page 199.
▶
Install the expansion card, see "Installing the expansion card" on page 221.
Concluding steps
▶
Install the corresponding riser module, see "Installing a riser module" on
page 69.
▶
"Reassembling" on page 57.
▶
If applicable, connect external cables to the expansion card.
▶
"Connecting the power cord" on page 62.
▶
"Switching on the server" on page 66.
▶
If applicable, "Installing the front cover with lock" on page 66.
▶
"Enabling replaced components in the BIOS" on page 88.
▶
Inform the customer about changed WWN, MAC and SAS addresses, see
"Looking for MAC/WWN/GUID and SAS addresses" on page 95.
Expansion cards and backup units
RX2530 M6 Upgrade and Maintenance Manual 231
To Next Page
Loading...
