Installing the new hot-plug PSU
▶
Install the PSU, see "Installing a hot-plug PSU" on page 110.
Concluding steps
▶
"Connecting the power cord" on page
62.
▶
Only when replacing a PSU in a non-redundant configuration: "Switching on
the server" on page 66.
▶
"Performing a fan test" on page 103.
Performing a fan test is not needed if the system power was off and
DC stand-by power was available (AC power cord connected, but no
system power on) when replacing the PSU.
Power supply unit (PSU)
116 Upgrade and Maintenance Manual RX2530 M6
To Next Page
Loading...
