2.5-inch HDD/SSD subsystem
–
Up eight 2.5-inch SAS/SATA HDD/SSD modules can be installed depending
on configuration.
The HDD/SSD modules are connected to the HDD backplane wirelessly
.
This allows HDD/SSD modules to be plugged in or pulled out easily. If the
HDD/SSD modules are controlled by a RAID controller, defective HDD/SSD
modules can also be replaced during operation.
–
Up to 10 2.5-inch HDD / SSD / PCIe SSD modules can be installed
depending on configuration.
The HDD / SSD / PCIe SSD modules are connected to the HDD backplane
wirelessly. This allows HDD / SSD / PCIe SSD modules to be plugged in or
pulled out easily.
If the HDD / SSD / PCIe SSD modules are controlled by a RAID controller,
defective HDD / SSD / PCIe SSD modules can be replaced during
operation.
For information on RAID controllers controlling the HDD/SSD modules,
see "Expansion cards and backup units" on page 195.
EDSFF SSD subsystem
–
Up to 32 EDSFF SSD modules can be installed.
The EDSFF SSD modules are connected to the EDSFF backplanes
wirelessly. This allows EDSFF SSD modules to be plugged in or pulled out
easily.
If the EDSFF SSD modules are controlled by a RAID controller, defective
EDSFF SSD modules can be replaced during operation.
For information on RAID controllers controlling the EDSFF SSD
modules, see "Expansion cards and backup units" on page 195.
Base units
There are four base units available.
Hard disk drive (HDD) / solid state disk (SSD)
RX2530 M6 Upgrade and Maintenance Manual 119
To Next Page
Loading...
