▶
"Connecting the power cord" on page 62.
▶
"Switching on the server" on page
66.
▶
If applicable, "Installing the front cover with lock" on page 66.
When the system is powered on after a CPU has been replaced or
upgraded, the Global Error indicator will start flashing with the message
CPU has been changed.
This only indicates that the CPU configuration has been altered. There
is no technical problem.
Proceed as follows:
●
Restart your server.
●
As soon as the startup screen appears, press the [F2] function key to
enter the BIOS.
●
If a password is assigned, enter the password and press
[Enter].
●
Select the Exit menu.
●
Select Commit settings and Exit.
●
Verify that the Global Error indicator stops flashing.
▶
"Updating or recovering the BIOS and iRMC S5" on page
79.
▶
"V
erifying the system time settings" on page 88.
▶
"Verifying system information backup or restore" on page 82.
▶
For memory configurations with Optane PMem modules: set the memory
operation mode in the BIOS in the same way as before replacing the system
board. For more information, see the corresponding BIOS Setup Utility
reference manual.
▶
If applicable, activate TPM functionality in the system BIOS under
Configuration > Security Configuration > TPM Support. For more
information, see the corresponding BIOS Setup Utility reference manual.
▶
"Looking for MAC/WWN/GUID and SAS addresses" on page 95.
▶
"Updating the NIC configuration file in a Linux and VMware environment" on
page 92.
▶
"Resuming BitLocker functionality" on page 93.
System board and components
RX2530 M6 Upgrade and Maintenance Manual 397
To Next Page
Loading...
