Fujitsu PRIMERGY RX4770 M6 - Page 213

▶
"Getting access to the component" on page 48
.
▶
"Locating the defective component" on page 44.
▶
Remove the corresponding riser module, see "Removing a riser module" on
page 63.
Removing the defective expansion card
▶
Remove the expansion card, see "Removing the expansion card" on
page 200.
▶
If the slot bracket on the defective expansion card is to be reused, remove it
from the expansion card, see "Removing slot brackets" on page 177.
Installing the new expansion card
▶
If applicable, install the slot bracket, see "Installing slot brackets" on
page 175.
▶
Install the expansion card, see "Installing the expansion card" on page 194.
Concluding steps
▶
Install the corresponding riser module, see "Installing a riser module" on
page 63.
▶
"Reassembling" on page 53.
▶
If applicable, connect external cables to the expansion card.
▶
"Connecting the power cord" on page 59.
▶
"Switching on the server" on page 60.
▶
If applicable,"Installing the front cover with lock" on page 61.
▶
"Enabling replaced components in the BIOS" on page 99.
▶
Inform the customer about changed WWN, MAC and SAS addresses, see
"Looking for MAC/WWN/GUID and SAS addresses" on page 106.
▶
"Updating the NIC configuration file in a Linux and VMware environment" on
page 104.
▶
"Updating expansion card firmware" on page 89.
Expansion cards and backup units
RX4770 M6 Upgrade and Maintenance Manual 213