9.6.4 Replacing a PCIe holder
Upgrade and Repair Unit
(URU)
Hardware: 5 minutes
Tools: Tools: Phillips PH2 / (+) No. 2 screw driver (for cover 2)
Preliminary steps
▶
If applicable, "Removing the front cover with lock" on page 45
.
▶
"Shutting down the server" on page 46.
▶
"Disconnecting the power cord" on page 47.
▶
"Getting access to the component" on page 48.
▶
If applicable, "Removing a riser module" on page 63.
Removing the defektive PCIe holder
Figure 108: Removing the PCIe holder (A)
▶
Press the flexible arm at both sides of the PCIe holder
. Make sure the align
pin has left from the align hole of rear wall (see close-up).
Expansion cards and backup units
RX4770 M6 Upgrade and Maintenance Manual 205
To Next Page
Loading...
