Enabling the TPM in the system board BIOS
▶
Switch on or restart your server.
▶
As soon as the startup screen appears, press the
[F2] function key to enter
the BIOS setup menu.
▶
Select the Configuration menu.
▶
Select the Security Configuration submenu.
▶
Set the TPM Support setting to Enabled.
▶
Under Pending TPM operation, select the desired TPM operation mode.
▶
Save your changes and exit the BIOS.
For more information on how to access the BIOS and modify settings,
see the corresponding BIOS Setup Utility reference manual.
15.4.4 Removing the TPM
Field Replaceable Unit
(FRU)
Hardware: 60 minutes
Software: 5 minutes
Tools: – Phillips PH2 / (+) No. 2 screw driver
– Bit screw driver
–
TPM bit insert
(*)
(*)
For Japan:
–
TPM module fixing tool (S26361-F3552-L909)
Preliminary steps
Preliminary steps are not necessary, if a system board has to be
replaced and the TPM is used again.
System board and components
336 Upgrade and Maintenance Manual RX4770 M6
To Next Page
Loading...
