Fujitsu PRIMERGY RX4770 M6 - Page 337

▶
Before removing the TPM board, remove the BitLocker protection and
decrypt the volume, see "Removing BitLocker protection and decrypting the
volume" on page 338
.
▶
Disable the TPM in the system board BIOS, see "Disabling the TPM in the
system board BIOS" on page 338.
▶
"Suspending BitLocker functionality" on page 81.
▶
If applicable, "Removing the front cover with lock" on page 45.
▶
"Shutting down the server" on page 46.
▶
"Disconnecting the power cord" on page 47.
▶
Remove all PSUs, see "Removing a hot-plug PSU" on page 126.
▶
"Getting access to the component" on page 48.
▶
Remove all riser modules, see "Removing a riser module" on page 63.
▶
"Removing the fan cage" on page 64.
▶
"Removing the air duct 1 (top system board)" on page 68.
▶
"Removing the top system board carrier" on page 73.
▶
"Removing the air duct 2 (bottom system board)" on page 69.
▶
"Removing the OCP air duct" on page 70.
▶
If applicable, remove the expansion cards from slot 3 to slot 9, see
"Removing the expansion card" on page 200.
▶
Disconnect the front panel cable from the bottom system board, see
"Removing the COP" on page 317.
▶
Remove the power distribution board, see "Removing the defective power
distribution board" on page 130.
▶
If applicable, remove the OCP module, see "Removing the OCP module"
on page 191.
▶
Remove the bottom system board, see "Removing the defective bottom
system board" on page 381.
System board and components
RX4770 M6 Upgrade and Maintenance Manual 337