Removing the cover 3
Figure 9: Removing the cover 3
▶
Loosen the screw (1).
▶
Push the cover 3 to the rear side using the green touch points (2).
▶
Remove the cover 3 upward (3).
4.6
Reassembling
4.6.1
Safety notes
CAUTION
▶
Before attaching the covers, make sure no unnecessary parts or
tools are left inside the server.
▶
The top cover must be replaced as soon as possible for purposes
of cooling, to comply with EMC regulations (regulations regarding
electromagnetic compatibility) and to prevent fires.
▶
For more information, see "Important information" on page 29
.
4.6.2 Installing the top covers
Tools: Phillips PH2 / (+) No. 2 screw driver (for cover 2 and cover 3)
Basic hardware procedures
RX4770 M6 Upgrade and Maintenance Manual 53
To Next Page
Loading...
