Fujitsu PRIMERGY RX4770 M6 - 15.9 System board

Concluding steps
▶
Install the two riser modules, see "Installing a riser module" on page 63
.
▶
"Reassembling" on page 53.
▶
"Connecting the power cord" on page 59.
▶
"Switching on the server" on page 60.
▶
If applicable, "Installing the front cover with lock" on page 61.
15.9 System board
15.9.1 Replacing the top system board
Field Replaceable Unit
(FRU)
Hardware: 25 minutes
Tools: Replacing the top system board:
–
Phillips PH2 / (+) No. 2 screw driver
–
Torx 30 screw driver
– Magnifying glass for inspecting CPU socket springs
(recommended)
Preliminary steps
▶
"Locating the defective server" on page 97.
▶
"Suspending BitLocker functionality" on page 81.
▶
If applicable, "Removing the front cover with lock" on page 45.
▶
"Shutting down the server" on page 46.
▶
"Disconnecting the power cord" on page 47.
▶
If necessary, remove all external cables from the expansion card.
▶
"Getting access to the component" on page 48.
System board and components
RX4770 M6 Upgrade and Maintenance Manual 373