10.6 Handling memory dummy modules
If the ATD 40 or ATD45 option is ordered for the server, it is required to
install dummy modules in free memory slots. There are different dummy
modules available. The variants can be mixed.
Removing a dummy module
â–¶
Eject the desired dummy module by pressing out the securing clips at each
end of the memory slot.
â–¶
Remove the ejected dummy module.
Installing a dummy module
â–¶
Press the securing clips on both sides of the memory slot concerned
outward.
Figure 145: Installing a dummy module - variant 1
Figure 146: Installing a dummy module - variant 2
Main memory
RX4770 M6 Upgrade and Maintenance Manual 253
To Next Page
Loading...
Need help?
General