4.5 Getting access to the component
4.5.1 Safety notes
CAUTION
▶
Only for non-hot plug components:
●
Before removing or attaching covers, turn off the server
, all
peripheral devices, and any other connected devices.
●
Because there is a risk of electric shock or damage, please
disconnect all power cords from the outlet.
▶
The top cover must be replaced as soon as possible for purposes
of cooling, to comply with EMC regulations (regulations regarding
electromagnetic compatibility) and to prevent fires.
▶
For more information, see "Important information" on page 29
.
4.5.2 Extending the server out of the rack
CAUTION
▶
Use the anti-tilt plate to prevent the rack from tipping when
installing the rack. Pulling the server out of the rack without having
installed the anti-tilt plate may cause the rack to tip over.
▶
Be careful not to pinch fingers or clothes when sliding out the
server or pushing it back. Failure to do so may cause injury.
▶
For maintenance procedures on the system board the rack must be
pulled out of the server and put on a even surface.
▶
Be careful not to damage the rack rails when sliding out the server
or pushing it back. Damaged rack rails may cause injury.
▶
For more information, see "Important information" on page 29
.
Basic hardware procedures
48 Upgrade and Maintenance Manual RX4770 M6