14.4 Front VGA
14.4.1 Replacing the front VGA
Upgrade and Repair Unit
(URU)
Hardware: 10 minutes
Tools: – Phillips PH2 / (+) No. 2 screw driver (for cover 1 and cover 2)
– hexagon screw driver 5 mm (for front VGA)
Preliminary steps
▶
"Locating the defective server" on page 97
.
▶
If applicable, "Removing the front cover with lock" on page 45.
▶
"Shutting down the server" on page 46.
▶
"Disconnecting the power cord" on page 47.
▶
"Getting access to the component" on page 48.
▶
Remove the two riser modules, see "Removing a riser module" on page 63.
▶
"Removing the fan cage" on page 64.
▶
"Removing the air duct 1 (top system board)" on page 68.
▶
"Removing the top system board carrier" on page 73
Front panel
RX4770 M6 Upgrade and Maintenance Manual 323
To Next Page
Loading...
