Fujitsu PRIMERGY RX4770 M6 - Page 249

Removing a memory module
Figure 143: Removing memory modules (A)
▶
Eject the desired memory module by pressing out the securing clips at each
end of the memory slot.
Figure 144: Removing memory modules (B)
▶
Remove the ejected memory module.
▶
If applicable, install a dummy module, see "Handling memory dummy
modules" on page
253.
Concluding steps
For memory slots on the bottom system board:
▶
"Installing the air duct 2 (bottom system board)" on page 72.
▶
"Installing the top system board carrier" on page 76.
▶
"Installing the air duct 1 (top system board)" on page 71.
▶
"Installing a riser module" on page 63.
▶
"Reassembling" on page 53.
▶
"Connecting the power cord" on page 59.
Main memory
RX4770 M6 Upgrade and Maintenance Manual 249