GE HEALTHCARE
DIRECTION FQ091013, REVISION 1 VIVID I N AND VIVID Q N SERVICE MANUAL
Chapter 3 - System Setup 3-49
3.) Connect one end of the S-Video cable to the S-Video OUTPUT on the video converter.
4.) Connect the other end of the S-Video cable to the VCR S-Video INPUT at the rear of the VCR.
Note: Dip switches are located beneath the video converter, as shown in Figure 3-46 below.
5.) Follow the manufacturer’s guidelines to set the switches to the correct positions, as shown in
Figure 3-47.
6.) When all power and signal cables are connected to the system, VCR, and video converter, proceed
as follows (in the order stated):
a.) Press the power ON switch on the VCR.
b.) Press the power ON switch on the video converter.
c.) Turn ON power to the Vivid i n/ Vivid q N system.
7.) Press the Input Select button (see Figure 3-45 on page 3-48) on the video converter three times
in order to select VGA Input as your signal source.
The LED located on the video converter front panel will be illuminated, accordingly.
Figure 3-46 Video Converter Dip Switches
Figure 3-47 Video Converter Dip Switch Positions
Dip Switches
To Next Page
Loading...
