GE Vivid i n - Page 171

GE HEALTHCARE
DIRECTION FQ091013, REVISION 1 VIVID I N AND VIVID Q N SERVICE MANUAL
Chapter 3 - System Setup 3-103
8.) Select Internet Protocol (TCP/IP).
9.) Click the Properties button.
The Internet Protocol (TCP/IP) Properties dialog box opens.
10.)Activate the Use the following IP address check box.
11.)Type in the Vivid i n/ Vivid q N IP address 10.0.0.1.
Note: The IP must be different from the IP address used for network computer.
12.)Type in the Subnet mask 255.255.255.0.
Note: The Subnet mask should be the same for both the network computer and the
Vivid i n/ Vivid q N.
13.)Click OK
14.)Press the Config button on the control panel to close all windows and return to the regular scanning
mode.
NOTE: The following steps are performed on the Network Computer.
1) On the network computer, access the Control Panel, as follows:
a.) Double-click on My Computer icon on desktop.
b.) Double-click on Control Panel icon.
2) Double-click on Network Connections icon.
3) Double-click on Local Area Connection icon.
Figure 3-107 Internet Protocol (TCP/IP) Properties