GE Vivid i n - Page 175

GE HEALTHCARE
DIRECTION FQ091013, REVISION 1 VIVID I N AND VIVID Q N SERVICE MANUAL
Chapter 3 - System Setup 3-107
The Local Area Connection Properties dialog box opens.
8) Select Internet Protocol (TCP/IP).
9) Click the Properties button.
The Internet Protocol (TCP/IP) Properties dialog box opens.
10.)Activate the Use the following IP address check box.
11.)Type in the Vivid i n/ Vivid q N IP address 10.0.0.1 or the one provided by the local network
administrator.
Note: The IP must be different from the IP address used for network computer.
12.)Type in the Subnet mask 255.255.255.0 or the one provided by the local network administrator.
Note: The Subnet mask should be the same for both the network computer and the
Vivid i n/ Vivid q N.
13.)Click OK
14.)Press the Config button on the control panel to close all windows and return to the regular scanning
mode.
Figure 3-111 Local Area Connection Properties
Figure 3-112 Internet Protocol (TCP/IP) Properties