GE Vivid i n - Page 177

GE HEALTHCARE
DIRECTION FQ091013, REVISION 1 VIVID I N AND VIVID Q N SERVICE MANUAL
Chapter 3 - System Setup 3-109
The Internet Protocol (TCP/IP) Properties dialog box opens.
6.) Activate the Obtain an IP address automatically check box.
7) Click OK, close all windows and approve all changes. Return to regular mode.
8) Connect the Vivid i n/ Vivid q N and network computer LAN connection using a regular Network
cable.
The Vivid i n/ Vivid q N and the network computer are now ready for export, import of files.
Note: One can check the connection by pinging to the Vivid i n/ Vivid q N IP, as follows:
a.) Select <Start>, <Run>
b.) Type CMD, then press <Enter>
c.) Type Ping and IP 10.0.0.1 for Vivid i n/ Vivid q N then press <Enter>.
If return timing is OK, you have an operating network connection.
Figure 3-114 Internet Protocol (TCP/IP) Properties