GE Vivid i n - Page 220

GE HEALTHCARE
DIRECTION FQ091013, REVISION 1 VIVID I N AND VIVID Q N SERVICE MANUAL
3-152 Section 3-10 - Connectivity Setup
3-10-9-3 Using MPEGVue Viewer on a Remote PC
3-10-9-3-1 Reading an MPEGVue Exam
An MPEG exam can be read on any computer with Windows 2000/XP/2003, provided that DirectX 8.1
(or later) and Windows Media Player 7.1 (or later) are installed.
NOTE: DirectX 9 and Windows Media Player 9 are recommended.
In addition, the following requirements should be met:
• CPU speed: 900 MHz or faster
• RAM Memory: 128 MB or higher
• Screen resolution: 1024 x 768 pixels (recommended)
• Colors: 24 bit or higher
• The PC should be configured for Auto-play.
To read an MPEGVue exam stored on a DVD/CD, proceed as follows:
• Insert the MPEGVue CD in the computer DVD/CD drive.
The MPEGVue Patient List is displayed (see Figure 3-161 below).
Note: In the event that the MPEGvue DVD/CD is being run for the first time, the program will
self-install the MPEGvue viewer. For more details, refer to Installing MPEGVue on a
Remote PC on page 3-136.
To read MPEGVue exams stored on other media:
1) Insert the media (MOD or Memory stick) containing the MPEGVue exams into the MOD drive (or
USB port) on the remote computer.
2) Double-click on the file START_MPEGVue.bat.
The MPEGVue Patient List is displayed (see Figure 3-161 below).
3-10-9-3-2 MPEGVue Patient List
The MPEGvue player will always start by showing the Patient List contained in the inserted media (see
the example below).
Figure 3-161 MPEGVue Patient List