GE HEALTHCARE
DIRECTION FQ091013, REVISION 1 VIVID I N AND VIVID Q N SERVICE MANUAL
Chapter 3 - System Setup 3-157
6) Type a unique password for the study.
Note: The password should be given to the recipient of the e-mail verbally by phone or by
other protected means.
(It is recommended to keep a separate record of passwords used).
7) Click Next.
The E-mail (addressed to the selected addressee) with the full examination attached is sent to the
Outbox; during this operation a series of progress windows are displayed, as seen in this example:
When the operation is complete, a Confirmation window is displayed as shown below.
8) Click OK to close the message window.
9) Check that the e-mail message has been sent from the Outlook Outbox.
Notes: Examinations sent by E-mail as attachments are compressed, encrypted, and
password-protected. If the size of the exam is too large to be sent as a single attachment,
it is divided into several zip file attachments sent with several independent E-mails, each
less than 1Mbyte in size.
The extension of the attached files is .mpegvue and can only be opened with the
MPEGvue viewer.
Sending an image by E-mail
Note: If this is the first time your recipient is receiving an MPEGVue image, it is necessary to
attach the MPEGVue Player - refer to the instructions for Sending the MPEGVue Player
Software by E-mail on page 3-159.
1) From the clipboard, select the image to be sent and click the E-mail button (#10 in Figure 3-162 on
page 3-153).
Figure 3-166 Sending Message to Outbox Progress Window
Figure 3-167 Operation Completed Message
To Next Page
Loading...
