GE HEALTHCARE
DIRECTION FQ091013, REVISION 1 VIVID I N AND VIVID Q N SERVICE MANUAL
5-24 Section 5-4 - Back End Processor
Figure 5-18 below shows a block diagram of the high level functions of the ETX Base Board.
Figure 5-18 ETX Base Board - Block Diagram
5-4-3-2 VGA Interface
The interface to the VGA is via the VGA connector on the rear side of the ETX Base Board. The VGA
port is connected to the DIB where VGA signals are converted to DVI and split into three channels to
drive the system LCD display (15" or 17", as applicable) and external monitor.
5-4-3-3 CardBus Interface
Not in use.
To Next Page
Loading...
