GE HEALTHCARE
DIRECTION FQ091013, REVISION 1 VIVID I N AND VIVID Q N SERVICE MANUAL
Chapter 7 - Diagnostics/Troubleshooting 7-57
7-4-4-3 Receive (RX) Tests
7-4-4-3-1 RX Test
NOTE: For a description of this test, refer to the information in RX Test on page 7 - 12.
NOTE: When performing this test, no probe should be connected to the system and nothing should be touching
the probe connectors!
1.) In the Diagnostic Test window, trackball to Rx Test in the list of RX tests available for selection from
the Diagnostic Test Tree (see Figure 7-32 below) and press Set. The RX Test name is displayed
under Execute; the relevant system components to be tested are highlighted light blue in the
Schematic View (TR32A. TR32B), as shown below:
2.) As indicated in the Special Instructions area, disconnect any probes currently connected to the
system and make sure that nothing is touching the probe connectors.
3.) Under the Special Instructions area, activate the Loops checkbox
and select the required number of Loops from the combo box.
4.) Adjacent to On Fail, select either Stop or Continue, as required.
Stopping on failure enables you to review a failed test, the moment it fails. Alternatively, you may
prefer testing to continue on failure and later you may review the report.
5.) Trackball to the Start button and press Set.
The Rx Test commences. While the test proceeds, the name of the test currently in progress
(Rx Test) is displayed in the Execute field and the current Loop # and specific test are shown below.
The messages Init Done and Please Wait are displayed beside the progress bar in the Status area.
NOTICE
IMPORTANT In order to access an individual board test, it is necessary to insert the service dongle from
system boot-up and enter the Service Password.
Figure 7-32 Rx Test
To Next Page
Loading...
