GE HEALTHCARE
DIRECTION FQ091013, REVISION 1 VIVID I N AND VIVID Q N SERVICE MANUAL
8-42 Section 8-3 - Internal Component Replacement Procedures
8-3-3-5 BEP Installation Procedure
NOTE: When performing the following installation procedure steps, it may be helpful to review the appropriate
movie clips previously referenced in the BEP Removal Procedure.
NOTE: The SATA BEP has an adaptor bracket, which is required for its installation. The bracket is shown on
the left in Figure 8-51; in the picture on the right, the bracket is shown in position in the Vivid i n/ Vivid
q N scanner. Notice that the bracket sits on the PCMCIA slot-flap, which is pressed open while the
adaptor bracket is positioned on the flap itself. To install the adaptor bracket, the flap is pressed open
(Figure 8-52) and the adaptor bracket is placed in position. The procedure is described below.
Figure 8-51 SATA Adaptor Bracket
Figure 8-52 PCMCIA Slot Flap Pressed Open
SATA Adaptor Bracket
SATA Adaptor Bracket PCMCIA Slot Flap
PCMCIA Slot Flap Ready for Positioning the Adaptor Bracket
To Next Page
Loading...
