GE HEALTHCARE
DIRECTION FQ091013, REVISION 1 VIVID I N AND VIVID Q N SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-67
2.) Insert a shoulder screw into each screw hole (refer to Figure 8-75).
3.) Mount the AC Power Cable Bumper Protector onto the shoulder screws by aligning the mounting
tabs (ears) with the screws, then pushing the bumper downwards until it is seated securely.
See Figure 8-77.
4) Proceed to perform the following functionality tests:
- SafeLock Cart - Grounding Continuity on page 10 - 23
- SafeLock Cart - Chassis Current Leakage Test on page 10 - 25
Figure 8-77 AC Power Cable Bumper Protector Mounted on SafeLock Cart
AC Power Cable Bumper Protector
To Next Page
Loading...
