GE HEALTHCARE
DIRECTION FQ091013, REVISION 1 VIVID I N AND VIVID Q N SERVICE MANUAL
8-154 Section 8-7 - Peripherals
6) When done, click somewhere outside the name. The name will then be changed.
7) Record the Volume’s name on a sticker or a piece of paper and attach it to the drive so that it will
be easier to locate the correct drive in the future.
8) Use the “Safely Remove Hardware” tool in the Task Bar before continuing with the next step.
9) Disconnect the USB cable from the laptop or PC.
8-7-2-7 Connecting the External USB Hard Disk to the Vivid i n or Vivid q N Scanner
1) Connect the USB cable to a USB port on the Vivid i n or Vivid q N scanner.
2.) Turn ON power to the Vivid i n/ Vivid q N ultrasound scanner.
3) Under My Computer (refer to Figure 8-153 on page 8-153), verify that the drive appears for
selection.
4) Proceed to perform the following functionality tests:
- External USB Hard Disk Test on page 4 - 32
To Next Page
Loading...
