UCM6200 Series User Manual
• Default Code: *81
• To page an extension, enter the code followed by the extension
number.
• Default Code: *80
• To intercom an extension, enter the code followed by the
extension number.
• Default Code: *40
• To add a number to blacklist for inbound route, dial *40 and
follow the voice prompt to enter the number.
• Default Code: *41
• To remove a number from current blacklist for inbound route,
dial *41 and follow the voice prompt to remove the number.
• Default Code: **
• To pick up a call for any extension xxxx, enter the code followed
by the extension number xxxx.
• Default Code: *45 (Disabled by default).
• If “Pickup In-call” feature is enabled, only the extensions added
in “Allowed to seamless transfer” in the extension’s Seamless
Transfer Privilege Control List” can pick up the call.
• Default Code: *8
• This code is for the pickup group, which can be assigned for
each extension on the extension configuration page.
• If there is an incoming call to an extension, the other extensions
within the same pickup group can dial *8 directly to pick up the
call.
Direct Dial Voicemail Prefix
• Default Code: *
• This code is for the user to directly dial or transfer to an
extension's voicemail.
• For example, directly dial *5000 will have to call go into the
extension 5000's voicemail. If the user would like to transfer the
call to the extension 5000's voicemail, enter *5000 as the
transfer target number.
Direct Dial Mobile Phone Prefix
• Default Code: *88
• If you have the permission to call mobile phone number, use
this prefix plus the extension number can dial the mobile phone
number of this extension directly.
To Next Page
Loading...
Need help?
General
