ADVANCED FUNCTIONS AND OPERATIONS: Setting the Registration Mark Mode
6-21
6.12 Setting the Registration Mark Mode
This function is used to align media with printed markings such as registration
marks with the plotter’s X and Y axes.
• The line thickness must be between 0.3 to 1.0 mm for auto registration mark
recognition.
• Media that is not white and lines in colors other than black may not be read
correctly.
• If the edges of the registration mark lines are blurred, they may not be read
correctly.
• If there is any dirt in the reading area, the plotter may recognize it incorrectly as
a registration mark.
• If the media used is not suitable for auto registration mark recognition, use the
axis alignment function to perform manual recognition.
• Use the POSITION keys to move the pen carriage within the registration mark
reading mark area before performing auto registration mark recognition.
• When the media is loaded in the plotter, the lower-left registration mark (when
viewed from the front of the plotter) must be positioned at a distance of at least
22 mm from the left edge. If the distance is less than 22 mm, a registration
mark reading error may occur.
SETTING PROCEDURE
1 Raise the media set lever. The following menu appears.
2Press the F4 key (INITIAL MENU). The following menu appears.
3Press the F1 key (AUTO REG. MARK). The following menu appears.
LOAD MEDIA!
INITIAL MENU>
AUTO REG. MARK>
AUTO PRE FEED>
INITIAL FEED SPEED>
INTERFACE>
MARK SCAN MODE>
MARK TYPE>
OTHER SETUPS>
Registration mark pattern 1
Media feed direction
Registration mark pattern 2
At least 22 mm At least 22 mm
To Next Page
Loading...
