ADVANCED FUNCTIONS AND OPERATIONS: Setting the DISTANCE ADJUST Function
6-56
6.30 Setting the DISTANCE ADJUST Function
This function corrects any deviation in the length of cut or plotted line segments,
which occurs depending on the media being used. The adjustment value for the
deviation is specified as a percentage of the total distance. For example, a setting
of 0.05% adjusts a distance of 2 m (2,000 mm) by +1 mm (2000 x 0.05% = 1 mm),
to become 2,001 mm. The DISTANCE ADJUST function can be specified
individually for each of the cutter-pen condition setting areas.
SETTING PROCEDURE
1Press the MENU key.
2Press the NEXT key until the following menu appears.
3Press the F4 key (OPTION 2). The following menu appears.
Note: PEN OFFSET ADJ. is only displayed for 2-pen models.
4Press the F3 key (DISTANCE ADJUST). The following menu appears.
5 The numbers at the right of CONDITION are the condition setting numbers 1 to
8. Use the ( ) POSITION keys to move the cursor to the number that you
wish to change the setting for. Use the (▲▼) POSITION keys to specify
ENABLE or DISABLE for each number. A mark appears under the number
when ENABLE has been selected for that number, and tangential control will
be performed for each of the specified condition numbers.
6Press the ENTER key to register your setting. If you wish to cancel your
selection, press the NEXT key.
This setting is retained in the plotter’s internal memory even when the power is
turned off.
PEN UP/DOWN>
BACKGROUND SETTINGS>
OPTION 1>
OPTION 2>
PEN OFFSET ADJ.>
INITIAL DOWN FORCE>
DISTANCE ADJUST>
TEST>
DISTANCE ADJUST
CONDITION 12345678
-
▲
▼
To Next Page
Loading...
