BASIC FUNCTIONS AND OPERATIONS: Using the MOVE STEP Function
5-13
5.9 Using the MOVE STEP Function
This function specifies the length of the step moved whenever a POSITION key is
pressed.
SETTING PROCEDURE
1Press the MENU key.
2Press the NEXT key until the following menu appears.
Note: ASSIGN PEN is only displayed for 2-pen models.
3Press the F4 key (MOVE STEP). The following menu appears.
4 The asterisk “*” indicates the currently selected setting. Press the F3 key (0.1
mm) or the F4 key (1 mm) to move the asterisk to your desired setting.
5Press the ENTER key to register your setting.
6Press the MENU key to return the plotter to Ready status.
This setting is retained in the plotter’s memory even when the power is turned
off.
ASSIGN PEN>
CROSS CUT>
PRE FEED>
MOVE STEP>
MOVE STEP
0.1 mm*
1 mm
To Next Page
Loading...
